Have city water pressure from your rural water well with the Flint and Walling constant pressure submersible pump system.

Flint & Walling Pumps
from Dean Bennett Supply Co
Ph. 800-621-4291

Industrial Grade Heat Tape for water pipe protection against freezing.

Flint and Walling submersible water well pumps are available 
in 4 inch submersible pump models from 5 gpm to 85 gpm sizes.

LAKOS SAND SEPARATORS

 

Flint and Walling water well pumps offer you the right pump for any water well pump requirement.

4 inch submersible pump installation instructions

Pump Sizing Questions

 F&W Pumps
Select the 4 inch submersible pump that is right for your water well conditions.
4 inch deep well submersible pumps are designed to pump from deeper water wells where other pumps would not perform.
Constant pressure submersible water well pumps give you water pressure like the city water system does.
6 inch submersible pumps are used in irrigation water wells where large volumes of water need to be pumped in a short period of time.
SPJ lawn sprinkler pumps are ideal for lawn irrigation from a pond or shallow well.
Centrifugal pressure booster pumps are used to produce higher pressure at head feet above normal centrifugal pump capacity.
Artesian Variable Frequency Drives
Uniform pressure centrifugal pumps give a constant water flow at a specific pressure to give constant pressure at the tap.
High pressure booster pumps boost incoming pressure to a desired level of pressure.
Jet pumps are used on the surface to draw water from a well. Shallow well jet pumps pump from 20 feet or less, and 2 pipe deep well jet pumps pump from deeper depths.
Deep well vertical jet pumps are 2 stage jet pumps to pump from deeper depths and give more gallons per minute.
Submersible pump wire connects with power at the top of the well and connects underwater to the motor lead.
UF direct burial wire cable is used to run power from the power source underground to a well.
Aie E Tainer pressure tanks buffer your water pressure to give you a more even pressure when you open the tap. The pressure tank also acts as storage to have a certain amount available before your pump needs to turn on.
BW LH systems protect your pump from running out of water in a low producing water well.
BW RH systems control power to a well pump to keep a cistern full of water.
Sand Blocker drive point screens have 2 layers of stainless steel for strength and stainless steel wool in between the layers to filter out smaller particles and allow the maximum water flow through.
A water well pump system needs many smaller items that are used to complete the pumping system. Water well accessories covers the item needed to complete your pump installation.
Setting a submersible pump into a well requires the use of special tools to control lowering the pipe.
Gas driven pumps make it possible to transfer water from a stream or holding tank to another point at a fast rate of speed.
Galvanized steel pipe tank nipples are threaded all the way to allow conncetion of a pipe through a tank wall.
Wintergard heat tapes are used to keep water lines from freezing during the cold of winter.

Flint and Walling Inc. has been making water pumping systems since 1866. From their small foundry beginning, F&W began to grow when they started introducing plumbing equipment and wooden hand pumps. F&W grew through the windmill era, and then into the domestic water age as electric pumps became the future. Today, F&W produces a full line of water pumps for domestic water wells, livestock water supply, sprinkler systems, and commercial irrigation purposes. If it is for pumping water, Flint & Walling has a pump to fill your water pumping needs.


Aermotor windmills are american made with pride and quality.

Search for
 
Aerrmotor windmill is a thing of beauty on the horizon. Aermotor Windmills Windmills pump water with wind power making the energy cost free.
Aermotor windmills are the standard to compare to. When you need to pump water for livestock, or just want the original Aermotor windmill to view, there is no other that carries the same feeling, look, or quality.
MADE IN THE U.S.A.
Windmill towers are made from steel to support the water pumping Aermotor windmill in strong winds.
We stock a full line of repair parts for your Aermotor windmill. Call us for the parts you need.
Baker hand pumps are just like the hand pumps you use at state parks. Pump water without power and be more independent.
Baker pump jacks pump water with a cylinder and rod, powered by an electric motor or a gas engine.
Windmills pump water with a stroke cylinder that lifts water from the well to the surface.
Deep well pumping cylinders are used with larger windmills, or where a water well is real deep.
Windmill cylinders need rod to connect the pumping cylinder to the windmill stroke mechanism.
Cylinder cup leathers for pumping water with windmill or hand pump well cylinder pumps.
Windmill stuffing boxes are packing glands that prevent water from leaking out around the rod the traverses through the stuffing box to pump water.
Bob Float valves control water level in stock tanks, by opening a valve as the water level drops and clocing it when the desired level is achieved.
Reliable stock tank floats are flat floats that are used to activate a float valve to control water level in stock water tanks.
Stock tank heater deicers are used to keep livestock water tanks open during winter months.
Wintergard heat tape is ideal for protecting water lines from freezing in the cold of winter.
Windmill systems require several accessories to complete the windmill water pumping system.
Galvanized steel tank nipples are used to put a threaded nipple through the side of a water tank.
Through the wall seals can be accomplished with a pipe seal that expands into the opening as pipe is pushed through, creating a seal that does not leak.
When the wind doesn't blow hard enough for the windmill to pump, out pump and cylinder combination makes it possible to pump water with an electric submersible pump to keep water tanks full.
Windmills are desireable lawn decoration which can give a nostalgic feel to your lawn.
We have a manual for the 702 Aermotor windmill as well as a book written by an old time installer that will give lots of information about how your windmill works and how to maintain it.

Aermotor Windmills started in 1888. Since that time, there have been few changes in design of the workhorse we know as Aermotor. Harnessing the wind to pump water enabled the pioneers to settle land where surface water was non-existent. Today, the Aermotor still produces water for livestock throughout the country and many parts of the world.

FREE FREIGHT -- ORDERS OVER $ 1,000.00 SHIPPED FREIGHT PREPAID

 

FREE FREIGHT -- ORDERS OVER $ 1,000.00 SHIPPED FREIGHT PREPAID

Livestock tank heaters are used to keep ice from forming in a stock tank.

Zoeller pumps best buy models are the M267 automatic sewage pump and the M53 automatic sump dewatering pump. Zoeller quality sewage pumps and sump dewatering pumps will solve the most demanding sewage waste water elimination problem.
Affordable Zoeller sump dewatering pumps for every waste water elimination need.
Zoeller sewage waste pumps are known for their quality and performance.
Zoeller 820 grinder is the residentail grinder pump of choice for sewage that needs chewed up and pumped a long way away.
The 840 Commercial Grinder pump for sewage will reverse operation each time it starts to prevent blockages that can burn out a motor.
Zoeller offes an excellent replacement sewage grinder pump for a failed Hydromatic pump.
Zoeller Qwik Jon is a packaged system for adding a bathroom to a basement without tearing up the concrete floor.
The battery powered basement sentry backup sump dewatering pump is ideal for when you experience a power outage.
Homeguard offers you a reliable backup sump dewatering pump powered by water, when the power is off.
Zoeller package systems include a sewage basin with lid, a Zoeller automatic sewage pump and a sewage check valve.
The Outdoor burial sewage pump package consist of the M264 sewage pump, an 18" x 30" burial type basin with a solid lid and underground discharge.
Zoeller sewage collection basins are available in many sizes to meet most every sewage pumping requirement.
Rail systems assist you in removing or installing a sewage pump in a deep basin installed in the ground.
Zoeller crawl space dewatering pump package is a slotted poly basin for collecting ground water, an M53 automatic sump dewatering pump and a flexible ribbed hose for discharge of the collected water.
Zoeller float switches are used to control turning on and turning off a sump or sewage pump based on water level in a basin.
Zoeller check valves prevent sewage from running back into the sewage basin after the sewage pump turns off.
Zoeller pump control panels alternate power to 2 pumps turning them on and off, while offering a high water alarrm and capability of running both pumps if one does not keep up with demand.
Prevent discharge of oil hydrocarbons from your sump pump system.

Zoeller Pump Company began making sump and sewage pumps in 1939. Today they are the leading manufacturer of quality pumps for waste water and sewage pumping applications.

YOUR ORDERS SHIPPED SAME DAY FROM OUR DENVER WAREHOUSE

FREE FREIGHT -- ORDERS OVER $ 1,000.00 SHIPPED FREIGHT PREPAID

Dean Bennett Supply Company has been a stocking distributor of windmills, pumps, and well supplies since 1965. Whether your pumping needs are for household use or for livestock watering, our knowledgeable sales people will guide you to the correct products. Our large Denver inventory of well supplies will make fast delivery of your order easy. Your quality concerns will disappear when you can select brand name merchandise from well known manufacturers. We serve the rancher, home owner, and Do-It-Yourself installer in addition to the professional well driller / pump man -- So don't hesitate to call us for help on the products we sell you.       
WE WANT YOUR BUSINESS

Download our catalog in pdf format


WANT OUR 75 PAGE COMPLETE WELL SUPPLY CATALOG?
We will be glad to send you our full catalog. It is absolutely free and will be sent to you via Priority Mail. Every possible water well supply item you could need is both priced and described in our catalog. 
CLICK HERE FOR OUR CATALOG REQUEST FORM    If you experience problems ordering a catalog, please email us at pumpsdbs@aol.com with your name, mailing address, and area of interest. Be sure to tell us you had trouble on http://www.flintandwallingpumps.com and the page whether contact.htm or catalog_form.htm .
 

PREFER TO PERSONALLY VISIT WITH OUR SALES PEOPLE?   Call us at no cost on our nationwide toll free phone   ( 1 - 800 - 621 - 4291 )   Monday thru Friday    7 AM to 3 PM   Mountain Time Zone. Our sales people will be glad to answer your questions, take your order, or help you in any other way we can on products we sell.

Our Denver warehouse and office complex is not a retail type store front. All sales and help is by phone only. All orders must be placed and paid for prior to your arrival at our will call counter, should you need to pick your order up in Denver.
Mail:    1770 East 69th Ave     Denver, CO     80229-7327
Phones:    Toll Free  800 - 621 - 4291    Local  303 - 286 - 1500
All phone lines are connected to our 24 hour message recording system.
Fax  303 - 286 - 0001

CONTACT US


Since 1965, Dean Bennett Supply has sold windmills, water well pumps, and sump and sewage pumps from Denver, Colorado.